2016NEW Cisco.CCIE.(400-101)EXAM] CCIE Routing and Switching EXAM A PART30 (681-700) VCE DUMPS FOR FREE DOWNLOAD WITH 100%PASS ENSURE

Do you want to pass the 400-101 Examsavior exam? What are the new questions of the latest 400-101 exam? Examsavior 400-101 VCE dumps and 400-101 PDF dumps will tell you all about the 400-101 Examsavior exam.Here are the Examsavior newest and covered all new added questions and answers, which will help you 100% passing  400-101 Examsavior exam.Hurry up and get the free exam from here!

NOW FREE DOWNLOAD

QUESTION 681

DRAG DROP

Drag each routing protocol on the left to the matching statement on the right.

Select and Place:

Correct Answer:

Section: Mix Questions

Explanation

Explanation/Reference:

QUESTION 682

Refer to the exhibit.

R1 and R2 both advertise 10.50.1.0/24 to R3 and R4 as shown. R1 is the primary path. Which path does traffic take from the R4 data center to the file server?

A. All traffic travels from R4 to R2 to the file server.

B. All traffic travels from R4 to R3 to R1 to the file server.

C. Traffic is load-balanced from R4 to R2 and R3. Traffic that is directed to R3 then continues to R1 to the file server. Traffic that is directed to R2 continues to the

file server.

D. All traffic travels from R4 to R2 to R1 to the file server.

Correct Answer: A

Section: Mix Questions

Explanation

Explanation/Reference:

QUESTION 683

Which two statements about path selection are true? (Choose two.)A. If there are multiple equal matches between OSPF processes, the path with the lowest OSPF PID is chosen.

B. If the backdoor command is configured on a BGP network, the route is advertised with an AD of 20.

C. If an OSPF E2 route has an AS of 90, that path is preferred over an OSPF IA route with an AD of 110.

D. If there are multiple equal matches between the same protocols on an EIGRP network, the preferred path will be EIGRP with the highest AS.

E. If IS-IS has multiple routes with the same prefix-length, it will prefer Level 1 routes over Level 2 routes.

Correct Answer: AE

Section: Mix Questions

Explanation

Explanation/Reference:

QUESTION 684

Which two statements about BGP prefix-based outbound filtering are true? (Choose two.)

A. It must be configured per address family.

B. It can use prefix lists and route maps for filtering.

C. It can be configured under the global BGP routing process.

D. It can be configured for external peering sessions only.

E. It can increase the processing load on the router.

F. It supports IP multicast routes.

Correct Answer: AD

Section: Mix Questions

Explanation

Explanation/Reference:

QUESTION 685

Which statement about OSPF loop prevention is true?

A. The discard route is generated automatically on the ABR to prevent routing loops.

B. The ASBR uses type 3 LSAs from non-backbone areas to prevent control-plane routing loops.

C. The ABR can filter type 3 LSPs to prevent routing loops.D. The DN bit ignores LSA types 2, 3, and 5 to prevent routing loops.

Correct Answer: A

Section: Mix Questions

Explanation

Explanation/Reference:

QUESTION 686

Which three options must be configured when deploying OSPFv3 for authentication? (Choose three.)

A. security parameter index

B. crypto map

C. authentication method

D. IPsec peer

E. encryption algorithm

F. encryption key

G. IPsec transform-set

H. authentication key

Correct Answer: ACH

Section: Mix Questions

Explanation

Explanation/Reference:

QUESTION 687

Which two statements about redistribution are true? (Choose two.)

A. When BGP traffic is redistributed into OSPF, the metric is set to 1 unless the metric is defined.

B. When EIGRP routes on a CE are redistributed through a PE into BGP, the Cost Community POI is set automatically.

C. When OSPF traffic is redistributed into BGP, internal and external routes are redistributed.

D. When BGP traffic is redistributed into OSPF, eBGP and iBGP routes are advertised.

E. iBGP routes automatically redistribute into the IGP if the routes are in the routing table.

F. When EIGRP traffic is redistributed into BGP, a default metric is required.Correct Answer: AB

Section: Mix Questions

Explanation

Explanation/Reference:

QUESTION 688

RIPv2 is enabled on a router interface. The “neighbor” command is also configured with a specific IP address. Which statement describes the effect of this

configuration?

A. RIP stops sending multicast packets on that interface.

B. RIP starts sending only unicast packets on that interface.

C. RIP starts ignoring multicast packets on that interface.

D. RIP starts sending unicast packets to the specified neighbor, in addition to multicast packets.

Correct Answer: D

Section: Mix Questions

Explanation

Explanation/Reference:

QUESTION 689

Which three types of address-family configurations are supported in EIGRP named mode? (Choose three.)

A. address-family ipv4 unicast

B. address-family vpnv4

C. address-family ipv6 unicast

D. address-family ipv6 multicast

E. address-family vpnv6

F. address-family ipv4 multicast

Correct Answer: ACF

Section: Mix Questions

Explanation

Explanation/Reference:QUESTION 690

Which two improvements do SIA-Query and SIA-Reply messages add to EIGRP? (Choose two.)

A. Stuck-in-active conditions are solved faster.

B. They prevent a route from going into the stuck-in-active state.

C. They help in the localization of the real failure in the network.

D. The EIGRP adjacency between two neighbors never goes down.

Correct Answer: AC

Section: Mix Questions

Explanation

Explanation/Reference:

QUESTION 691

Which three address family types does EIGRP support? (Choose three.)

A. IPv4 unicast

B. IPv4 multicast

C. IPv6 unicast

D. IPv6 multicast

E. IPv4 anycast

F. IPv6 anycast

Correct Answer: ABC

Section: Mix Questions

Explanation

Explanation/Reference:

QUESTION 692

Which two statements about EIGRP load balancing are true? (Choose two.)

A. EIGRP supports 6 unequal-cost paths.B. A path can be used for load balancing only if it is a feasible successor.

C. EIGRP supports unequal-cost paths by default.

D. Any path in the EIGRP topology table can be used for unequal-cost load balancing.

E. Cisco Express Forwarding is required to load-balance across interfaces.

Correct Answer: AB

Section: Mix Questions

Explanation

Explanation/Reference:

QUESTION 693

Refer to the exhibit.

All routers are running EIGRP and the network has converged. R3 and R4 are configured as EIGRP Stub. If the link between R1 and R3 goes down, which

statement is true?

A. R1 sends traffic destined to 192.168.0.100 via R2.B. R2 does not have a route to 192.168.0.0/24 in the routing table.

C. The prefix 192.168.0.0/24 becomes stuck-in-active on R4.

D. R3 does not advertise 192.168.0.0/24 to R4 anymore.

Correct Answer: B

Section: Mix Questions

Explanation

Explanation/Reference:

QUESTION 694

Which three statements about EIGRP wide metrics are true? (Choose three.)

A. The maximum metric is 65536.

B. The default delay is 1,000,000 picoseconds.

C. They allow up to 100 hops.

D. They allow up to 256 hops.

E. The default delay is 1,000,000 milliseconds.

F. The maximum metric is 51200.

Correct Answer: ABC

Section: Mix Questions

Explanation

Explanation/Reference:

QUESTION 695

An NSSA area has two ABRs connected to Area 0. Which statement is true?

A. Both ABRs translate Type-7 LSAs to Type-5 LSAs.

B. The ABR with the highest router ID translates Type-7 LSAs to Type-5 LSAs.

C. Both ABRs forward Type-5 LSAs from the NSSA area to backbone area.

D. No LSA translation is needed.

Correct Answer: B

Section: Mix QuestionsExplanation

Explanation/Reference:

QUESTION 696

Which two OSPF network types require the use of a DR and BDR? (Choose two.)

A. non-broadcast networks

B. point-to-point networks

C. point-to-multipoint networks

D. broadcast networks

E. point-to-multipoint non-broadcast networks

Correct Answer: AD

Section: Mix Questions

Explanation

Explanation/Reference:

QUESTION 697

Which packet does a router receive if it receives an OSPF type 4 packet?

A. hello packet

B. database descriptor packet

C. link state update packet

D. link state request packet

E. link state acknowledge packet

Correct Answer: C

Section: Mix Questions

Explanation

Explanation/Reference:

QUESTION 698

Which two statements about OSPFv3 are true? (Choose two.)A. It supports unicast address families for IPv4 and IPv6.

B. It supports unicast address families for IPv6 only.

C. It supports only one address family per instance.

D. It supports the use of a cluster ID for loop prevention.

E. It supports multicast address families for IPv4 and IPv6.

F. It supports multicast address families for IPv6 only.

Correct Answer: AC

Section: Mix Questions

Explanation

Explanation/Reference:

QUESTION 699

DRAG DROP

Drag each OSPF route-type identifier on the left to its description on the right.

Select and Place:

Correct Answer:

Section: Mix Questions

Explanation

Explanation/Reference:

QUESTION 700

Which three options are characteristics of a Type 10 LSA? (Choose three.)

A. It is an area-local, opaque LSA.

B. Data is flooded to all routers in the LSA scope.

C. It is used for traffic-engineering extensions to OSPF.

D. It is a link-local, opaque LSA.

E. Data is flooded only to the routers in the LSA scope that understand the data.

F. It is used for traffic-engineering extensions to LDP.Correct Answer: ABC

Section: Mix Questions

Explanation

Explanation/Reference:

Latest online browsing the 400-101 exam!

400-101 PDF dumps & 400-101 VCE dumps: http://examsavior.com/400-101

	Examsavior	Test King	Pass4sure	Actual Tests	Other Brands
Customer Reviews
	$89.99	$124.99	$125.99	$189.00	$29.99~$49.99
Up-To-Dated
Real Questions & Answers
Correct All Error
Premium VCE Dumps
Free VCE Simulator
Unlimited After One Time Purchasing
Instant Download
Printable PDF Dumps
100% Pass Guarantee
100% Money Back

100% Pass:http://examsavior.com/